Posted By
Spector
on 2004-10-18
10:35:39
|  Re: Turboloaders that work with Commando Plus4
Unfortunately, I couldn't get it to work at all. The same thing happens every time - the tap file appears to be loading, but at the end, it just says BREAK and some machine code letters and numbers. Every time it's the same thing.
This is what I did:
I loaded up Megacopy turboload
I load up commando.prg
I create a tap file called "commturb.tap" and check the wholewave tap box
I press F7- an autostart dialog box appears. I then press cancel to get rid of it.
I press F4, which brings up the SYS prompt.
It says on the screen - sA"
I delete the sA" and write save"commturb",7
It then says press play and record on tape, so I select record in the YAPE options, and it starts recording.
At about 200K it stops. I detach the TAP.
I make a hard reset of the plus4 and try to load it in again. It fails at the end of the tape by saying "BREAK" and underneath some machine code registers are printed.
I don't know what I'm doing wrong. Anything obvious in my description?
|
