Posted By
gmontag451
on 2022-10-07
17:50:09
|  Plus/4 conversion of CMD FD-Tools
I recently converted CMD's FD-Tools program to work on the Plus/4, from the FD-Utilities disk for the CMD FD disk drives. It was a simple conversion; I just changed some addresses, pointers and screen codes. I didn't convert any other programs on the disk because I never use them (and assembly is tedious.) 
Would there be any interest in this and if so where is a good place to upload it?
|
|
Posted By
Csabo
on 2022-10-07
20:03:04
| Re: Plus/4 conversion of CMD FD-Tools
Sure, one of the few ambitious goals of Plus/4 World is to collect all software written for the Plus/4. You can upload it via the SiteUploader.
|
|
Posted By
gmontag451
on 2022-10-07
22:00:45
| Re: Plus/4 conversion of CMD FD-Tools
Thanks for the link, done!
(Just an FYI, it requires an FD drive to be connected and turned on for it to work.)
|
|
Posted By
Csabo
on 2022-10-08
10:02:52
| Re: Plus/4 conversion of CMD FD-Tools
Thank you, it's up: FD-Tools. I also added at least one drive to the hardware section: CMD FD-2000.
|
|
Posted By
gmontag451
on 2022-10-10
00:49:24
| Re: Plus/4 conversion of CMD FD-Tools
Great, thanks!
|
|
