Posted By
SVS
on 2002-11-23
 |  To have good results by %S,
you have to calculate the optimizing interleave value. This depends by the rotation speed of your drive motor and *could* be set with a screwdriver.
When for example you set an higher speed, you could have as optimized interleave: 7.
After this you have to run the command to set 7 as DOS parameter.
Only now you can write a file. When reading it you finally should obtain a speed increase 
These operations are a bit dangerous because, as I experienced, you have very little range to modify motor speed, without affect the working of fastloads.
Then: do your tests on a spare-disk! 
P.S. Who is "someone"? 0
|
