Posted By
crock on 2011-10-22 12:21:50
| Re: Pre production Plus4 board manufacturing fault
Well, it did actually , although the fault may have been there already. One of the drams had a column stuck high. Fortunately is was easy to trace and replace the culprit. It's 100% again now.
My diagnostic setup has loopback dongles on all the external ports. The user port specifically has checks for the 8 general i/o ports and on the RS232 RTS/CTS Rx/Tx, DCD/DSR.
See the movie here:
http://www.youtube.com/watch?v=BCw3PD5cb88
Rob
|