Posted By
SVS on 2007-07-27 10:51:49
| Re: 1551 - alignment?
Advanced procedure:
Once open the drive, run the utility Floppy-Einstellhilfe. Now, with a plastic screwdriver you can set the screw in order to obtain the better (shorter) time (output by utility on screen) that with a 1551 is about 9. This means that you have phisically aligned the head and made as fast as possible the reading. Do not set a value too much low (8 or less for the 1551) because you could be nomore able to read next disk (you should need a second running unit in order to load the utility to restore a good speed). At last, check some fastloader if still continue to work. If not stepup the value (9 -> 9,2 for example).
The same procedure works on a 1541x but the optimal value is greater (10).
Hope have helped.
|