Posted By
C=Owl27
on 2020-10-04
00:42:45
 |  Is the a .PRG version if DIAG264?
I was able to make a power supply for my sd2iec
(which would only connect to the C64 previously)
Now I can load up all the programs.
But one thing I would like to run is DIAG264
I won't be getting my I/Cs and sockets for a while longer,
but my Plus4 can start up and load programs from my regular 1541.
So it could be that if there is a .PRG version of Diag264,
I could load it from the sd2iec and run it?
The bin file will load in an emulator but I'm not sure it will from the sd2iec or in plus4.
I'm going to try a little later, but will have to dismantle my modern computer,
and set up the plus4 to do so.
I've searched for hours before I go on to do this,
I have little room in my apartment.
I've searched for convert bin to prg,
I found in Vice the cartconv CMD app.
which converted diag264 to a crt,
then I converted the crt to a prg.
But when I ran the prg version in an emulator,
it didn't seem to work.
It may be that cartconv only handles C64 stuff.
Any advice would be very appreciated.
Thank you plus4world for being here. 
|
