Posted By
JledStev61
on 2020-09-07
00:07:15
|  Re: Questions about Plus4 Saver
[I think you'd better replace the power connector in the Plus4 and install a C64 one.]
Is a good idea. But I only have a Plus4 supply.
I am hesitant to cut it for putting in the saver in the cord.
Otherwise I will have to find another 4pin din for an external saver.
That seems to be hard part going about it.
Maybe I think I just to put the saver inside the Plus4.
[The Plus4 doesn't have a 7805 inside]
Oh. That is why I did not find one.
But I think there is one inside the C16. Unless I am mistaken.
Also the 64 of course.
About my LEDs, I can not figure the ballast resistance for my LEDs.
C= powers supply = v5
LED Vf = 5v 10ma
5 - 5 = 0 / .01 = 0
So no resistance?
But everyone says there still needs to be resistor anyways.
I don't know why the LED is rated so high in volts. (they are labeled superbrite)
I may just buy different ones.
Or just put a 470 to it anyways.
My multimeter won't measure it like it does the 2volt ones I have.
Package says it is 5Vf.
And about the relay.
I will just use the SRD-05vdc-sl-c instead
and it will use the amps fine anyways.
I looked at your DIAG 264 and really intrigued.
When I get my situation settled I will get one of those for sure.
And that was interesting what plugged into the keyboard slot.
|
