Posted By
George on 2017-02-02 17:18:52
| Re: Creating new Speech Data for the V364
@Gaia Yes, i have smartphone Conection (64kb/s)
Well after reading Stefans site again (The parameter dump is there too) i could find out, what you mean. The parameters have different lenghts.
My next try with the parameter dump of the word "Zero". I wrote a converter for the dump. I played around with the Config-Byte, and got different variations.
Zero_00.PRG Zero_09.PRG Zero_0A.PRG
Start the programm and type: VOC 24576 SAY 1024
We got a step further. At least, we created somthing near to the word "Zero".
******************************************************************* Edit 02.02.2017 ******************************************************************* @Gaia: The SPTK works in windows. Thank you for the help.
I was able to make a PACOR Data file:
Here are the steps: 1.) Make from a wave file a raw-file: wav2raw.exe data.wav data.raw 2.) Make from a raw file a float-file: x2x +s data.raw > data.f 3.) Make from a float.file a Parcor file: frame < data.f | window | lpc -m 10| lpc2par -m10 > data.rc
Here is the point, where we i am stuck. When you put data.rc into the Prg-file you get nice "Alien"-talk for the next Star Wars movie.
sample.PRG
The questions are: A) Which format must the Source Wave-File have? b) The conversion to PARCOR is made in 3 steps (Window, lpc und lpc2pa command). Each has further parameters, which i dont understand. How must the parameters be set, to match the expected Paramaters from the Toschiba-Chip?
Without any further Infomation from the designers, this might me hard to find out. Maybe somebody knows the right guys (Bill Herd, etc) to ask?
|